1XA160.5 Owner’s Manualpass®XA160.5 Owner’s ManualApril 25, 2007
10XA160.5 Owner’s ManualAfter that, the longevity will depend upon the number of operating thermal cycles, but we can say that we have had amplifiers
11XA160.5 Owner’s Manual
12XA160.5 Owner’s ManualWarranty InformationAll Pass Laboratories products purchased new from an authorized Pass Laboratories dealer in North America
13XA160.5 Owner’s ManualWater and moisture: Electrical devices should not be used near water ( as per example, near a bathtub, washbasin, kitchen sin
2XA160.5 Owner’s ManualNelson Pass has been designing audio electronics since about 1971, first with ESS (remember Heil transformers?), and then formi
3XA160.5 Owner’s ManualWe start with simple FET circuits already having low distortion and noise, and arrange them in two symmetrical halves. The two
4XA160.5 Owner’s ManualAll the usual performance metrics - power, distortion, noise, input impedance, damping factor and bandwidth have all been impro
5XA160.5 Owner’s ManualSET UPX amplifiers run at about the same power as their output rating, and XA amplifier run more than twice that. The heat sin
6XA160.5 Owner’s Manual The amplifier’s voltage and current rating are indicated on the rear panel. It will be either 240 volts, 230 volts, 220 volts
7XA160.5 Owner’s ManualSo the amplifier is sitting there unconnected.Make sure that the rear panel power switch/breaker is off (down). Plug the AC c
8XA160.5 Owner’s Manualpin 3 is inverted (negative) input. Pin numbers are marked on the XLR. If you re-install the jumper incorrectly or leave it
9XA160.5 Owner’s Manualthe temperature exceeds 75 degrees Centigrade. This thermal cutout should never occur in real life. This is a very rare occur
Comments to this Manuals